Kingston ValueRAM KVR13N9S8/4 4GB PC3-10600 CL9 DDR3-1333

---

Kingston ValueRAM KVR13N9S8/4 - 4GB PC3-10600 CL9 240-pin DIMM - DDR3-1333

4GB DDR3 geheugenmodule. De verpakking is geopend geweest, maar de module is nieuw en ongebruikt wegens bestelling van het verkeerde type. De originele aankoopbon is aanwezig (7 juli 2016, 99 dagen garantie).

Voor reacties en informatie a.u.b. 'E-mail deze adverteerder' gebruiken.


Specificaties van de fabrikant:

DESCRIPTION
This document describes ValueRAM's 512M x 64-bit (4GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM), 1Rx8 memory
module, based on eight 512M x 8-bit DDR3-1333 FBGA components.
The SPD is programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V. This 240-pin DIMM uses
gold contact fingers. The electrical and mechanical specifications are as follows:

FEATURES
JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
VDDQ = 1.5V (1.425V ~ 1.575V)
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address 000 only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration: Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
Asynchronous Reset
PCB: Height 0.740 (18.75mm) or 1.180 (30.00mm)

SPECIFICATIONS
CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.125ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 36ns (min.)
Maximum Operating Power TBD W*
UL Rating 94 V - 0
Operating Temperature 0°C to 85°C
Storage Temperature -55°C to +100°C